Norm-O-Temp® Patient Hyperthermia System

The NORM-O-TEMP® Model 111W hyperthermia system is intended to prevent hypothermia during surgical procedures and to reduce cold discomfort before, during, and after a surgical procedure.

Specifications:

- Dimensions:
+ 22.86 cm Wide
+ 38.14 cm Deep
+ 46.99 cm High

- Weight: 
+ 15.2 kg empty
+ 20.6 kg filled

- Ambient Temperature (during use): 15°C – 30°C (59°F – 86°F)

- Cabinet Construction: Powder-coated steel with plastic top. Dual reservoir. Built-in handles.

- Warning:
+ High Temperature: Audible and Visual
+ Low Water: Audible and Visual
+ Defective Water Temperature Sensor: Audible and Visual
+ Water Flow Indicator: Visual
+ Power Failure: Audible and visual
+ Greater than 1° Over Set point: Audible and Visual

- Control System: Microprocessor-based temperature control system, and Alarm indications.

- Controller Range:
+Heating Only: 32°C - 42°C
+ Water Temperature: ±0.6°C
+ Water Temperature Display: 0°C - 52°C
+ Water Temperature increments: 1°C

- Display Type: LED Display.

- Electrical Characteristics:
+ 230V, 50Hz, 4.8 Amps
+ 240V, 50Hz, 4.6 Amps

- Heater Power: 800 watts

- Power Cord: 16/3 Detachable, IEC 320

- Leakage Current: Under 500µa 230/240 VAC

- Fuse: 5 Amp in IEC 320 connector

- Mains Supply Isolation: Two-Pole Mains Switch

- Safety System
+ Maximum High Control Setting  42°C
+ Primary Temperature Limit: 43.5°C ± 0.6°C
+ Secondary Temperature Limit: 44.5°C ± 0.6°C
+ Independent Mechanical Temperature Limit: 46°C ± 0.6°C

- Ambient Temperature (transportation and storage):
+ Temperture: -40°C – +50°C
+ Humidity (transportation and storage): 20% – 95%

Temperature regulating blanket:

- PlastiPad® reusable blankets for adults, children and infants:

- Maxi-Therm® Lite Single-Use Blanket:

- The Gelli-Roll pad combines patient temperature management with comfort. The pad is a reusable water blanket encapsulated in soft, compressible polymer gel that conforms to the patient’s body shape and may be used before, during or after surgery.